Anodize remover - 16 oz.

  • Click to enlarge
Anodize remover - 16 oz.

Tap to enlarge

$18.00


Product Information
Specification

Anodize remover - 16oz or 1 gallon sizes.

This concentrated formula is mixed with warm water to make a solution to completely strip the anodized coating from aluminum trim and parts.  This product leaves a dull surface that can be easily buffed to a mirror finish using our a soft buffing wheel and #739 white compound. 

Also available in 1- gallon size (see option below)-additional shipping charges may be applied to larger size

Anodize Coating Remover Instructions:

Directions: Mix 4-5 Tablespoons of anodize powder per 1 gallon of warm/hot water in a plastic or stainless container. (Cold water will not activate the solution) Stir until completely dissolved. Place parts into container for 5-10 minutes. (solution should begin to bubble) Remove parts and rinse with cold water, Use Jestco Products #739 White compound and buff to a mirror finish. Some anodize coating are thicker and will need to be dipped into solution for an additional amount of time. It is recommended to try a sample part before beginning.

Caution: Use outside in well-ventilated area Wear protective gloves, mask and eye protection as needed. Keep container sealed tightly and out of reach of children.

Dispose of properly by diluting with cold water.

Product Code797
Stock Level695
ConditionNew
Weight3lb

Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

Please enter a valid email address.
This field is required.
Top

Follow Us

Mailing List

Enter your e-mail address to receive our newsletter
Please enter a valid email address.
Email address already subscribed. Continue if you wish to unsubscribe.
Subscribe
Unsubscribe

eCommerce by CubeCart