Instructions for Polishing

Stainless Steel

 Step 1 - Begin by applying #739 compound (white - polish) to a buffing wheel and buff part. Re-apply compound to buffing wheel as necessary. This will buff the part to a mirror like finish. Many stainless trim parts can be completed with only this compound. Only use the abrasives below if necessary.

Step 2- (If necessary) Use #755 compound (gray - mild abrasive) on a separate buffing wheel to remove any scratches that remain after step 1. Repeat step 1 to achieve the mirror finish.

Aluminum casting, Mag wheels, Brass castings.

 Step 1 - Use #737 compound (black heavy abrasive) on a separate buffing wheel to remove heavy scratches and oxidation.  this compound cuts aggressively and smoothes the surface. The #759 Tripoli compound (optional)can be used on top of the abrasive to give it a smoother finish.

Step 2 – apply #739 compound (white - polish) to a separate buffing wheel and buff part. Re-apply compound to buffing wheel as necessary. This will buff the part to a mirror like finish. Remove compound residue with a rag and mineral spirits.

Anodized Aluminum

Use this process for aluminum trim which has the hard anodized coating.

Step 1 – remove coating using anodize remover #797 mixed with hot or warm water. This process usually takes 15-20 minutes.

Step 2 - Begin by applying #739 compound (white - polish) to a buffing wheel and buff part. Re-apply compound to buffing wheel as necessary. This will buff the part to a mirror like finish. 

Step 3- (If necessary) Use #755 compound (gray - mild abrasive) on a separate buffing wheel to remove any scratches that remain after step 1. Repeat step 1 to achieve the mirror finish.

Step 4 - (If necessary) Use #737 compound (heavy abrasive) on a separate buffing wheel to remove heavy scratches. Repeat step 1 to achieve the mirror finish

Notes:

 ·       Use #789 (Red) jewelers compound with a clean buffing pad for the finest finish. This compound can be used on all metals with a soft buffing wheel for the best possible finish.

·       Use buffing rake #779 to periodically clean and soften the surface of the buffing wheel. Use after every 5-6 application of compound

·       Use #920 Wenol polish with a soft rag to further clean and polish the surface and protect the surface. Using an orbital polisher is recommended for removal of swirls marks.

·      Always wear protective gloves, Respirator and eye protection.